Chamfering of cylindrical gears: Innovative new cutting solutions for efficient gear production
Cylindrical gear chamfering and deburring is a rather “unloved” process that adds cost but without delivering readily apparent improvements in […]
Chamfer Hobbing Tools Up
In the last few years, chamfering and deburring have gained new respect and risen to a level of importance equal […]
Taking deburring to the next level
Once a gear is created, deburring becomes a necessary step to ensure a gear’s accuracy. Traditionally, deburring has been done […]
Chamfer Hobbing, Perfect Timing
New gearbox developments, particularly for eDrives, are creating a whole new set of gear design and manufacturing criteria. Compact gearbox […]
The Bold New World of Chamfering and Deburring
If there’s a “red-headed step child” among the cylindrical gear manufacturing processes today, it’s chamfering and deburring. Since these operations […]
An Introduction to Shot Peening for Increasing Gear Fatigue Life
While everyone is familiar with sand blasting, people erroneously believe that shot peening is the same thing. However, the two […]
Case Study: Abtex Corporation and an Automotive Gear Manufacturer
Since 1980, Abtex Corporation — headquartered in Dresden, New York, the Finger Lakes area of New York State — has […]
New Hobbing Solutions for Faster Production of Automotive Transmission Gears
Today’s consumers take for granted that their cars’ transmissions — whether manual, automatic, or differential, luxury or entry level — […]
Weighing Options in Deburring
In the gear deburring process, the operator must determine the method, or tool, that will be used. Three tool options […]
Gearing Up to a Better Chamfering and Deburring Process
As with any machining process, the manufacturing of gears by hobbing or shaping results in burrs on the front edge. […]
Contemporary Gear Pre-Machining Solutions
Depending on annual production volumes, batch sizes, and workpiece geometry, several gear manufacturing technologies are used for industrial gear production. […]
Robotic Gear Processing
Henry Ford once said “If you need a new process and don’t install it, you pay for it without getting […]
High Pressure Water Deburring
Increasingly, gear manufacturers and others are expected to deliver burr-free clean parts to the point of use. To meet this […]
Overcoming the Chamfering Technology Impasse
While the gear-making industry has seen many technology advances with respect to the sophistication of other necessary equipment, the process […]
Turbo – Abrasive Machining for Edge and Surface Finishing
Turbo-Abrasive Machining [TAM] is a mechanical deburring and finishing method originally developed to automate edge finishing procedures on complex rotationally […]
