Marposs Corp. will present its new Mida Laser 75P non-contact programmable tool setting system at EASTEC 2009 in booth #3006 May 19-21. For reliable performance under the harshest of conditions, the high precision Mida Laser 75P incorporates a patented protection system with air tunnel effect, powerful integrated microprocessor for best performance under coolant, active drip rejection filter, and enhanced noise reduction with double filtering technology. The programmable feature of the Mida Laser 75P unit enables the system to be adapted to the tool type under verification, to the same rotation speed as used during machining and to the desired measuring cycle.
The Mida Laser 75P system is available with a “collimated” or “focused” laser beam. The focused model is essential for cutting edge integrity verification and length measurements of chisel or rounded nose tools, or for tools with a diameter of less than 1 mm. Typical uses of the Mida Laser 75P include tool identification, tool breakage detection, pre-setting of unknown tools, tool dynamic length and diameter measurement, tool wear compensation, tool cutting edge profile integrity verification, and machine axis thermal drift compensation. In addition to the system’s standard parallel I/O, the Mida Laser 75P incorporates an RS232 serial communication port that allows the exchange of data during the measuring cycle to improve accuracy and repeatability results in harsh conditions, easier retrofitting without any M-code, and to facilitate correct installation check and troubleshooting.
Other new products being presented by Marposs at EASTEC include the Mida Optical Twin Probe interface unit and a new “P3SE” electronic unit for machine analysis and feedback.
To learn more call (888) 627-7677, e-mail marposs@us.marposs.com, or go to [www.marposs.com].
